izmir escort

antalya escort

izmir escort

porno

porno izle

bursa escort

escort

mobil porno

havalandirma sistemleri

antalya escort

beylikdüzü escort

takipçi satın alma

instagram beğeni hilesi

instagram takipçi hilesi

saha betonu

izmir escort

eskisehir escort bayan

porno yabanci

takipçi al

beğeni al

takipçi satın al

beğeni satın al

takipçi satın al

takipçi satın al

izmir eskort

sex hikaye

takipçi satın al

takipçi satın al

ifşa türk

adana bayan escort

ümraniye escort

mudanya escort

şaşmaz escort

tunceli escort

bayan escort

instagram satın al takipçi

instagram satın alma takipçi

Smm panel dünyanın en ucuz sistemi

istanbul escort

escort

porno video

porno izle

P0054-00 error code
500 Madness
   
  
Results 1 to 2 of 2

Thread: P0054-00 error code

  1. #1
    Junior Member
    Join Date
    Sep 2018
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts

    P0054-00 error code

    My Fiat 500x 1.4 Multiair Manual has a P0054-00 error code fairly regularly. The engine warning light is sometimes on with the fault but not always.

    It think this means HO2S Heater Resistance Bank 1 Sensor 2 is reading incorrectly and that probably means a new sensor assuming the wiring is ok.

    These are what I think are the relevant readings in my Multiecuscan (4.6R1).

    Lambda 1 signal (After-Cat.) This ranges between 0v and 1.3v
    Lambda sensor 1 integrator This ranges around the 1 mark plus or minus a small amount
    Lambda sensor 2 integrator This is nearly always exactly 1 except when it occasionally reads just below 1
    Lambda 1 status (Pre-Cat.) This is nearly always closed loop
    Lambda 1 status (After-Cat.) This is nearly always open loop
    Lambda 1 diagnosis (Pre-Cat.) This varies between 'Rich' and 'Lean'
    Lambda 1 diagnosis (After-Cat.) This varies between 'Rich' and 'Lean'

    My questions are:

    Is it normal for the post cat sensor to be open loop nearly all the time I'm driving? It goes closed loop at higher revs sometimes and then Lambda sensor 2 integrator reads something other than 1.

    Do the readings for the Lambda 1 signal (After-Cat.), Lambda sensor 2 integrator, Lambda 1 status (After-Cat.) and Lambda 1 diagnosis (After-Cat.) have any relevance to the P0054 error?

    Sorry for the length of this. Looking forward to any comments. I hope this isn't a case of a little knowledge is a dangerous thing on my part. TIA.

  2. #2
    Junior Member
    Join Date
    Nov 2022
    Location
    Thailand
    Posts
    1
    Thanks
    0
    Thanked 0 Times in 0 Posts

    Диагностика в Бутово

    *хоКГ в Платной https://www.allergyfreeclinic.ru дешево.
    Платная клиника https://www.allergyfreeclinic.ru

Similar Threads

  1. Mass Error Code Appearing Suddenly
    By TheChad in forum Fiat 500 Issues and concerns
    Replies: 6
    Last Post: 11-18-2021, 05:43 PM
  2. P0325 error code
    By glutch in forum Fiat 500X Issues and Concerns
    Replies: 7
    Last Post: 05-03-2020, 04:47 PM
  3. Error code: P1CEA
    By Ventura24 in forum Fiat 500L Issues and Concerns
    Replies: 1
    Last Post: 01-03-2020, 01:15 AM
  4. What should dealership do for error code p106b?
    By LaneyBear in forum Fiat 500 Issues and concerns
    Replies: 12
    Last Post: 10-15-2018, 04:58 PM
  5. P0138 error code
    By boriqua935 in forum Fiat 500 ABARTH General Discussion
    Replies: 3
    Last Post: 10-21-2015, 07:52 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •