bursa escort beylikdüzü escort meyve siparişi istanbul escort istanbul escort escort mersin escort kayseri bursa escort bayan kocaeli escort atasehir escort bayan escort bursa bursa escort banko tahmin escort bursa escort bursa bursa escort bursa escort escort kıbrıs bodrum escort canakkale escort afyon escort isparta escort marmaris escort muğla escort fethiye escort trabzon escort aydın escort sivas escort manisa escort yalova escort tekirdag escort izmir escort antalya escort izmir escort porno porno izle bursa escort escort izmir escort bursa escort izmir escort izmir escort istanbul escort
Seat fold/tilt cable. - Page 2
500 Madness
   
Page 2 of 2 FirstFirst 1 2
Results 11 to 13 of 13

Thread: Seat fold/tilt cable.

  1. #11
    Senior Member streetsurfer's Avatar
    Join Date
    Mar 2013
    Posts
    1,168
    Thanks
    353
    Thanked 377 Times in 307 Posts
    I am not sure on that housing. Does it also come out of the housing at another point to release a catch? So you think it is only binding in the larger black plastic mechanism housing? I would think it is either removed in some other way or the seat cover and foam are removed to better accessed when needed, and no the welds would not need to be dfeated for work on it. Not familiar with that mechanism, but have repaired detached cable ends before. Sorry, not much help.

  2. #12
    Junior Member
    Join Date
    Nov 2018
    Posts
    7
    Thanks
    0
    Thanked 1 Time in 1 Post
    I don’t think it’s necessarily binding in there as much as I think it’s just straight stopping. Almost as if there is a knob on the cable to prevent it from sliding all the way out and hits the black mechanism I referred to. My problem is that the strap does not cause the seat to fold down, so I think it either fell out of its track or broke at the end where the release is at.

    Any direction or advice is greatly appreciated. I’m hoping it’s eaiser than I’m making it. Thanks for choking in!

  3. #13
    Junior Member
    Join Date
    Nov 2018
    Posts
    7
    Thanks
    0
    Thanked 1 Time in 1 Post
    Bump / help / please

Page 2 of 2 FirstFirst 1 2

Similar Threads

  1. Fold Flat Front Passenger Seat
    By carfreak09 in forum Fiat 500X
    Replies: 8
    Last Post: 08-10-2016, 03:11 PM
  2. New design driver-side seat recliner release cable module making creaking noise
    By LilSilverBullet in forum Fiat 500 ABARTH Issues and Concerns
    Replies: 3
    Last Post: 07-30-2016, 06:38 PM
  3. Leaving the fold!
    By fig32 in forum Fiat 500 ABARTH General Discussion
    Replies: 16
    Last Post: 01-26-2016, 09:10 PM
  4. Vents above radio no longer tilt up/down
    By slowbird in forum Fiat 500 ABARTH Issues and Concerns
    Replies: 11
    Last Post: 07-24-2014, 02:58 PM
  5. Welcome to the Fold !
    By MrFiat in forum Fiat 500 ABARTH General Discussion
    Replies: 9
    Last Post: 04-28-2012, 07:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •