What did you do to your Abarth today..?

[RexS]

!11111.jpg154386109_225022035983124_1856050927568613594_n.jpg!11.jpg

A little teaser going out. Door panels done, Seat kit in hand (front only, rears gone) awaiting install next week and new mats on the way.

[lammie200]

I put on the GFB DV this afternoon. Really smooths out the driving experience.

[shabba]

I installed a Forge wastegate actuator in palce of my OEM that was mostly frozen. I was surprised by how much boost I was apparently missing.

[BigDaddySRT]

I installed a Forge wastegate actuator in palce of my OEM that was mostly frozen. I was surprised by how much boost I was apparently missing.

Don't exceed 18 psi boost with the Factory PCM.

[abarthshep]

my "today" is over the last week or so. I've;

replaced my multiair unit due to my cylinder #4 VVT acting up. I thought this would be a crazy process (mostly due to the dealer quoting close to $2,000). I had a used multiair unit and did the install in my underground garage in about 4 hours (could have been much less, but TBH i was terrified due to not having the proper locking tool. Turns out it's not necessary)

I also replaced all 4 of my spark plugs, and put in some Eldor 4C coils. Noticeable difference at idle and when revving, however have not seen any difference on the top end like others have claimed with the Bosch coils.

I replaced my shift knob and boot with a Mishimoto carbon fiber knob, and a cheap Brisk boot from amazon. It's honestly insane how much of a difference this made in the feel of shifting, even with the stock shifter.

I replaced my rear brake pads and rotors (canadian tire cheapies), again in my underground garage. Thought I'd be able to retract the piston with a pair of needlenose, but i couldn't get it to compress while turning. Luckily a buddy from my building had a piston compress kit. When doing my rear passenger side, I realized my bearing was completely shot. Had that changed at the mechanic

Ordered an oil catch can, however every video I watch of an install is different. Holding off on that for now

Stopped filling up with Petro 94, changed over to Shell 91 due to 0 ethanol. Changed my EC tune to Phase 1 / 695 with pops and bangs.

I think that's it for now :P

[abarthshep]

Bigdaddy, are you saying not to exceed 18 psi on stock tune?

[map]

!11111.jpg154386109_225022035983124_1856050927568613594_n.jpg!11.jpg

A little teaser going out. Door panels done, Seat kit in hand (front only, rears gone) awaiting install next week and new mats on the way.

I love the door panel treatment. Did you have to drill it all out like Chris' article? Any hints where you got your covers? (The black fabric on my door panels pick up a lot of dirt; have been thinking of covering those.)

[BigDaddySRT]

Verus Engineering Hood Vents

[Hugo L.]

!11111.jpg154386109_225022035983124_1856050927568613594_n.jpg!11.jpg

A little teaser going out. Door panels done, Seat kit in hand (front only, rears gone) awaiting install next week and new mats on the way.

Wow amazing!

[BigDaddySRT]

Texas Region SCCA Solo II
Event#1