So, I've been running my top hats for for about 2 years. I noticed that they have no cover like the oem units. One of mine went bad, not sure if I hit a pot hole or something and damaged it or water/dirt got in and killed it. It was full of muck.I don't have a garage so my car sees rain and snow. I was thinking about looking for a rubber/plastic dust cap to seal out the elements. Any thoughts or ideas? Thanks.

Howdy Has anyone found a higher pitched horn that is an easy retrofit ? My 2012 Cabrio horn just does not get other traffic attention when needed. Looking for an easy install from say Toyota products etc. More European higher pitched.

thanks

David

So, recently I've had a clunk noise for over 2 weeks. I couldn't dial in where it was coming from but today discovered it was coming from the driver's side CFP bearing. It would make a clunk noise when I turned the steering wheel at a certain position. Noticeable when parallel parking. I punched the bearing out and cleaned any rust/old grease and put some bearing grease on it and reinstalled. Seems to be better but not sure how long.I've had the top hats on for almost 2 years now. Love them but do they just sell the bearings?

Need to know what to replace the missing bolt below with.

[ATTACH=CONFIPXL_20220508_223559744.jpgG]41268[/ATTACH]

Attached Images

• PXL_20220508_223559744.jpg (120.8 KB)

Hello All,

Anyone know the location of the fuel tank pressure sensor?

Is it near the sending unit? Anything to be mindful of when disconnecting it?

I just cleared a mil light and noticed the voltage was 318v, lol...

Anyone have similar experience?

Thanks,

Arman