PDA

View Full Version : Floor Jack LoProfile



Motoguzzi
07-12-2012, 03:31 PM
Been using these for some time..
AC Hydraulic DK13HLQ..
Its a good solution for low clearance and long reach/lift applications..
Highly recommend these jacks and the jack stands are super sweet too..
http://www.acjacks.com/
The rubber pad on the lift point was an option when I picked up my last one, its a good thing to have with the jack..

Frankly I would like to see each studio equipped with at least one of these.

On a side note I am concerned about the lifts that the some studios are using as I feel the lift blocks are marring the rust sealant specifically on the rear lift points.. This does not need to happen as most lift manufacturers offer specialty pads that are protective, as we have one chassis to support this would be inexpensive for the studios and protect our cars from rust and damage..

Cheers Motoguzzi